Well Pump Repair in West Jordan, UT

Weak pressure, a pump that won't shut off, or no water at all? Start with the free fixes below — most low-pressure calls end at step 1 or 2. If it turns out you need a hand, we'll connect you with a licensed local well & pump technician who serves West Jordan and the rest of the Salt Lake Valley.

Before You Call a Repair Tech: Free Fixes First

A surprising number of "pump problems" turn out to be something cheaper. Before booking a repair, rule out these first — they take a homeowner 10-30 minutes and no special tools:

• Clogged sediment filter — if you have a whole-house filter before the pressure tank, swap the cartridge. This alone fixes a large share of low-pressure calls.
• Waterlogged pressure tank — a failed bladder is the second most common cause of weak or pulsing pressure, and it's a tank problem, not a pump problem.
• Pressure switch set too low — a switch set to 30/50 PSI can starve a two-story house. This is a $15-20 part if it needs replacing.
• Partially closed valve — check every shutoff between the well and the house.

Our full breakdown of all 8 causes, in order of how often they're the actual problem: Low Water Pressure in a House With a Well →

When It's Actually the Pump

If you've ruled out the filter, tank, switch, and valves and you're still losing pressure — or the pump is short-cycling, running constantly, or not building pressure at all — that points to the pump itself. A few signs it's time to call a professional rather than keep troubleshooting:

• The pump runs constantly and never satisfies the pressure switch
• You hear grinding, humming with no water movement, or repeated clicking
• Pressure has been declining gradually over weeks or months
• The well has sat unused for an extended period (seasonal cabin, new-to-you property)
• There's visible rust, mineral buildup, or water discoloration at every tap

How deep is your pump set?

Pump depth affects both what's likely wrong and what a repair or replacement costs — a pump set at 400 feet is a bigger job than one at 80 feet. If you don't know your setting, here's how to find out and why it matters: How Deep Should a Well Pump Be Set? →

What a Well Pump Repair Typically Involves

Every well is different, but a service call for a submersible well pump generally covers:

• Diagnosis — checking the pressure tank, switch, wiring, and pump performance to confirm the pump (not something upstream) is the actual problem
• Pulling the pump — for a submersible pump, this means pulling the drop pipe and wiring out of the casing, which is why depth affects cost and time
• Repair or replacement — a failed motor, worn impeller, or damaged wiring is usually a replacement rather than a repair; a bad check valve or pressure switch can often be repaired in place
• Reinstallation and testing — resetting the pump at proper depth, restoring pressure, and testing flow before the technician leaves

Actual cost depends heavily on pump depth, horsepower, and whether it's a repair or full replacement — a licensed technician can give you a real number after seeing your setup, which is exactly what the callback above is for.

Service Area

We work with licensed well & pump technicians serving West Jordan and the surrounding Salt Lake Valley, including:

Frequently Asked Questions

Related Guides

PressureTankSizer.com is an independent information site and does not perform well pump repairs directly. Submitting the form above shares your information with a licensed local contractor for the purpose of a callback and quote.